Tools & Equipment

My essential tools that get the job done!

iFixit Pro Tech Tool Kit

This is my go to kit for repairs containing a huge range of small bits to take just about anything apart. The Pro Tech Kit also has a range of try tools, spudgers and tweezers to pry open just about anything.

iFixit Mahi Driver Kit

For larger devices the Mahi kit contains larger bits than the ones found in the Pro Tech kit. While I use this kit a lot less frequently its just as awesome.

JC Pro1000s

When it comes to reprogramming phone components the JC Pro is a very capable device being able to reprogram LCD's, Batteries and flash memory. However it cannot reprogram home buttons or face sensors. 

Hot Air Rework Station

This is my cheap SMD soldering station, I mostly use it to heat up phones to soften adhesive when removing back panels and screens.

LCD Puller

An LCD puller is a great little tool to assist in lifting up phone screens. However the strong adhesive found on some phones can still make this progress difficult.

Magnetic Mat

Stop your screws from rolling around and have the ability to organise components and screw layout with the help of a magnetic mat. This can help avoid the risk of installing the incorrect screws when reassembling which can cause serious damage to components.

Suction Cups

For larger devices a few large suction cups can provide some more pulling power.

Razor Blade Set

Great for cutting and slicing this razor set comes with a huge range of different blades to cut just about anything including your finger if your not careful..

JC C2

A nifty little device for Apple phones which displays voltage and current reading of a device. It can also put a device into recovery mode and show the devices model, serial and ECID numbers. This is great for broken devices that have dead screens or are just a bare motherboard.

Power Supply

This is my home built power supply for testing electronics, while I don't use it for phone repair its great for other electronics projects. I used an old computer power supply and repurposed it with the help of a 3D printer. It outputs 3.3v, 5v and 12v. You can purchase commercially produced bench power supplies if building your own isn't for you.

Thats all for now!

Please note: I receive a small amount of commission from products sold on iFixit's website when using the links above.

  • YouTube
  • Instagram - White Circle
  • Twitter

© 2020 Hugh Jeffreys